AdventistSat GEOSATpro DVR1000ci Guía de instalación descargar pdf (Pagina 37)

www.adventistsat.com Toll Free 866-552-6882

The satellite receiver features very sensitive Strength and

Quality meters to align the dish. Connect the LNBF output to the

satellite receiver SAT IN using the 25’ or 75’ coax cable.

Connect the satellite receiver TV OUT to the television set

When using a Lacuna, SatHawk, BirDog or SatBuddy digital

satellite location and identication meter, connect the LNBF to the

meter and use data for standard LNB type, KU, AMC4, Horizontal

and Vertical transponders. Peak for AMC4.

Antenna IN. Place the Output Selector

Switch on the back of the receiver to Channel

3 or 4 and select the same channel on the

television set.

Power ON the Master Power switch on

the rear of the receiver.

Power the receiver in the Operate mode

by pressing the Power button on the remote

control.

Press the MENU button.

Press the CH/DOWN arrow to select

Installation.

Press OK.

Enter password 0000 with the remote

numeric keypad.

10.

11.

Press the CH/DOWN arrow to select Antenna Setup.

Select satellite AMC4 KU by pressing the VOL/LEFT or

VOL/RIGHT arrow.

Press the CH/DOWN arrow to select the 2nd line. This line

selects the frequency that the receiver is tuning.

12.

13.

14.

The Signal Strength Level and Signal Quality is displayed in the

lower left corner of the screen.

1 2 ... 32 33 34 35 36 37 38 39

Sin comentarios

AdventistSat GEOSATpro DVR1000ci Guía de instalación Pagina 37