AdventistSat GEOSATpro DVR1000ci Guía de instalación descargar pdf (Pagina 38)

Select 11822 by pressing VOL/LEFT or VOL/RIGHT. (This

is 3ABN, the strongest transponder on the satellite).

Locate the satellite and peak Signal Quality reading by setting

the dish elevation and panning the dish side to side. As the dish is

directed at any one of the 30+ satellites visible over North America,

the signal strength reading will rise and fall. Only when the dish is

aimed at the correct satellite will the Signal Quality reading increase

above 10%.

Note: Signal Level is not important at this time.

If no

Signal Quality is detected, increase or decrease the elevation by

one degree and sweep once again. The elevation may need to be

adjusted up to +/- 5 degrees depending on the accuracy of the post

leveling and mechanical tolerances. Signal Quality must be at least

90% + on this channel.

Press VOL/RIGHT arrow to place the receiver on 12020.

(This is the LLBNchannel, a weaker transponder).

Verify the Quality reading is 70% +. If not, peak Quality

reading by ne tuning the dish angles.

Press EXIT button 3 times to exit the menus. Verify that all

AMC4 channels are being received.

The installation is complete!

15.

16.

17.

18.

19.

20.

Installer Tip: If you are having trouble locating the satellite,

remove the AdventistSat LNBF from the clamp and install a DirecTV

LNBF into the LNBF position. Locate the DirecTV 101w satellite

with a meter or DirecTV receiver. Replace the AdventistSat LNBFs

into the clamp. The dish is now roughly aimed and will only require

ne tuning for optimal reception of the linear satellite AMC4.

Set the Channel list to only display the AMC4 channels:

Press CH LIST button

Press the (Orange) LIST button.

Press VOL ◄ until satellite name AMC4/KU is displayed.

Press EXIT to view or listen to available AMC4 channels.

1 2 ... 33 34 35 36 37 38 39

Sin comentarios

AdventistSat GEOSATpro DVR1000ci Guía de instalación Pagina 38